The final and the most important step are testing. Every single device, module or just a printed circuit board is tested by our company. All interfaces and basic functionality are tested. For testing and measuring parameters, we use modern measuring and testing devices and instruments, so that the customer is..Read More



All devices developed and created by our company – electronic modules also contain the software. Nowadays, hardware and software are complementary. Software/firmware into the devices is designed and created based on specific customer requirements. It can only be an implementation of bios and API, with the programming of the higher..Read More

Soldering – PCB soldering and first start


Soldering, letovanie

No matter how well electrically designed a printed circuit board is, it is only as good as the quality of the printed circuit board itself, the use of high-quality components and, last but not least, the quality of the soldered parts. This phase can also be called as the first..Read More

Mechanical design and development of the enclosure


Sledovanie polohy v objektoch

All requirements for the mechanical design of the device, its assembly, location, connectors, requirements for IP protection and many other aspects are taken into the consideration during the phase of mechanical design and development of the enclosure. It is obvious that the visual appearance of the device sells and therefore..Read More

Printed circuit board design – PCB


The step of designing a prototype of printed circuit board is follows. The required functionality, whether electrical or logical, is verified and tested on a prototype piece. The proposal for the design are customer-defined dimensions, packaging or various terminals and connectors.

Schematic design


schematicka znacka pri navrhu dosky plosnych spojov

Based on previous meetings, measurements and consultations, a schematic design of the device is designed – an electronic module, which describes the basic electronic functionality of the device, its interfaces and electrical parameters.

Idea design


blokovo ideovy navrh

The whole process begins with a meeting with the customer, where the requirements for functionality, size, wired or wireless interfaces, display unit and other details about the device that the customer needs to design – create are presented. If necessary, a personal inspection of the installation site is planned and..Read More